Replacement for Weld-On A-Frame Coupler with 14,000 lb Capacity  

We have a bolt-on A-frame trailer coupler rated for 15,000 pounds, #BD44150WH301. It is the only bolt-on A-frame coupler we currently offer. It takes a 2-5/16 inch ball. The hole will accept an industry standard A-frame jack mounting pattern (holes 3…

The Dexter hub you referenced, 8-201, is a 5,200 lb hub, though a 5 on 4-1/2 bolt pattern does not come on 5,200 lb hubs. The correct bearings for the 5,200 lb hub are #25580 and #LM67048, while the proper races are #25520 and #LM67010. I have…

There are no repair kits available for the A-Frame Coupler #CA5400, so the best we can offer is to replace it with the same or, if you don't want the oily finish, the A-Frame Trailer Coupler #CA-5400-B.

The A-Frame Trailer Coupler part #CA-5400-B is a full replacement and the only way I know to repair it when it is broken. The Repair Kit for etrailer and Ram A-Frame Couplers part #CA-5100-RK is designed for original trigger latch couplers different…

The etrailer Weld-On A-Frame 2-5/16-Inch Coupler, part #CA5400, does not have any adjustment screw to enable you to take up the slack in the fit with your hitch ball. This coupler is produced by a stamping process and this type of manufacturing…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

I attached a picture that shows how much of the etrailer.com hitch part #E98901 would hang below the rear bumper when installed.

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…