Fuse Size in Curt Wiring Harness For Kia Sportage

Question

Question:

What size fuse is used in the kit? thanks

asked by: Adam C

0

Expert Reply:

A 10-amp fuse is used in the Curt wiring harness that fits your Kia Sportage, the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56321.

expert reply by: Kyle S

0

Answer 1

Often when a trailer harness lighting circuit stays on continuously, even when the vehicle lights are okay and function correctly, the issue is corrosion inside the vehicle socket or the trailer plug that allows the 12V auxiliary power signal to…

view full answer...

Answer 2

The issue is related to the stoplight circuit that the brake controller connects to with it's red wire. The red wire of the controller needs to connect to a circuit on the vehicle that only sees voltage when the brakes are applied. Most likely…

view full answer...

Answer 3

Brake controllers such as the P3 you referenced #90195 will go into a sleep mode after about 15 minutes of it sensing no movement. If you peek through the window after 15 minutes then it should be in sleep mode. Opening the door or causing movement…

view full answer...

Answer 4

Yes, it seems like you have a ground problem on the trailer. I would start by checking the ground wire at the trailer coupler and making sure it is connected to a solid clean paint free spot on the coupler of frame. Then I would check the tail light…

view full answer...

Answer 5

As much as you don't want to hear it there's no way to protect the converter box from bad trailer wiring. You wouldn't plug a brand new computer into an outlet that is sparking and constantly shorting out. You're going to need to fix…

view full answer...

Answer 6

This is usually caused by the trailer battery reaching the right brake and turn signal circuit, however this circuit should not be connected to the trailer battery. The first thing you can do is check the wire connections inside the of your trailer…

view full answer...

Answer 7

Under the hood of your 2005 Chevy Silverado there will be a 12 volt accessory circuit fuse that blew. I attached a picture for you to check out that shows exactly where the fuse will be.

view full answer...

Answer 8

It sounds like you have a short somewhere on your towing setup. I recommend isolating the issue by testing the pin on your tow vehicle side connector with a circuit tester like part #PTW2992. If it is not sending power when you take your foot off the…

view full answer...

Answer 9

Yes, trailer wiring harness #C56332 does have a fuse in a red holder near the large black converter box. If that fuse is fine, then use the vehicle owner's manual to find any fuses related to tow package wiring on the vehicle to check them. If…

view full answer...

Answer 10

In some instances, the final brake controller wiring connections for the 1999-2006 GM full size trucks weren't completed at the factory. I've linked you to our FAQ article that shows how to complete the wiring. Next to the fuse block under…

view full answer...

Answer 11

It sounds like you may have a loose wiring connection or a corrosion problem on the 7-way pin for the right turn/brake lights. This pin is the one at the 3-o-clock position as you're looking at the vehicle's 7-way; please refer to the linked…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Fuse Size in Curt Wiring Harness For Kia Sportage

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching