Installation of the Junior Locking Steel FlushDoor latch, Item # L1930

Question

Question:

How thick of a door can this latch work on. I am building my on door for a hunting house and would like to use your latch. also do you sale door kits?

asked by: Todd C

0

Expert Reply:

The Junior Locking Steel Flush Door Latch with Inside Release, item # L19730, is designed to fit through a 3/4 inch thick, or less door. At this time we do not carry door kits for enclosed trailers but we do carry hinges, door holders and other parts (see link) for enclosed trailers.

expert reply by: Robert G

0

Answer 1

The 113/108 L is the load index which is normally translated to pounds capacity. For instance the 113 is 2,535 lbs maximum capacity and 108 is 2,205 lbs. For instance the Westlake ST205/75R14 Radial Trailer Tire - Load Range D #274-000012 has a…

view full answer...

Answer 2

It depends on how the old one is attached to the door but you will likely have to pry it off. If there are no visible fasteners there wouldn't be any other way. You would have to be very careful not to damage the door in the process. When…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

view full answer...

Answer 7

You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…

view full answer...