Fulton XLT Powered Drive Trailer Jack for a Camper

Question

Question:

Hello, will the F141401 work for a camper trailer? I currently have a jockey wheel on it with a 1600lb capacity and only 10inch of travel where I need at least 18inch of travel. Thanks.

asked by: Jonathan W

0

Expert Reply:

Yes, the Fulton XLT Powered Drive Trailer Jack item # F141401 can be mounted on a camper. You will need to verify it will fit your tongue first. The bracket that mounts the jack to your trailer is made for 3" x 3" to 3" x 5" frames. This jack will allow up to 22" of lift using the 8" drop leg and 14" of screw travel. It has a 2,500 lbs capacity.

expert reply by: Jerred H

0

Answer 1

The Fulton XLT jack part #F141401 would need to run to the 12 volt accessory circuit of the 7-way on the trailer for the black wire and then to the ground circuit for the white wire. If you check out the attach diagram you'll see where these…

view full answer...

Answer 2

Thanks for the picture. Yes, that battery will be able to power the Fulton XLT Powered Drive Trailer Jack item #F141401.

view full answer...

Answer 3

You could use a 2-pole connector like the #HM47965 to wire the Fulton XLT Powered Drive Trailer Jack #F141401 to connect to the power and ground wire on the jack and route it to your vehicle battery, but a much easier way is just adding a 7-way…

view full answer...

Answer 4

Since none of our powered A-frame jacks are going to be short enough for what you said you'd need you'd have to use a side mount trailer jack like the Fulton part #F141401 which has a lifting capacity of 2,500 lbs. I know you said you wanted…

view full answer...

Answer 5

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 6

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 7

Hey Ryan, thanks for reaching out! The only true electric trailer jack made to fit a standard boat trailer with a pole tongue is the Fulton XLT Powered Drive Trailer Jack #F141401. Even though this is the only option available, Fulton has added some…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

I had our warehouse measure the Fulton XLT Powered Drive Trailer Jack #F141401 you were looking at and it has the following measurements. From top of mounting bracket to top of head assembly is 21", from the front to the back of the head…

view full answer...

Answer 10

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Fulton XLT Powered Drive Trailer Jack for a Camper

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching