Economical Replacement Jack For a 2004 R-Vision Trail Cruiser 21RBH With 3" Bolt Pattern
Question:
Looking for an electric tongue jack for 2004 Trail Cruiser 21RBH by R-Vision. Current manual A frame jack has 1000 lb capacity, three mounting bolts at 3 center-to-center. Looking for let expensive, easiest to install option.
asked by: Chuck
Expert Reply:
The Ultra-Fab Electric A-Frame Jack # UF38-944017 is one of our most economical jacks and has the same 3" on center bolt pattern. This jack is rated for up to 3,500lbs and comes with a 5-year warranty. To install you will simply bolt this jack in place of your old jack and connect the 2 power wires to your current wiring. I recommend using Deka Heat Shrink Butt Connectors # DW05745-5 to reduce the risk of water damaging the wiring connection.
Products Referenced in This Question
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Product Page this Question was Asked From
Ultra-Fab Electric A-Frame Jack - 18" Lift - 3,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Ultra-Fab Electric A-Frame Jack w/ 7-Way Plug - 18" Lift - 3,500 lbs
- Shop: Electric Jack w/ Footplate and 7-Way Plug - A-Frame - 25-1/8" Lift - 3.5K - Black
- Shop: Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Search Results: electric trailer jack
- Search Results: uf38~944017
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Trailer Wiring Diagrams
- Search Results: 44649
- Shop: Trailer Hitch
- Shop: Grease Seals 10-36 (pair)
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 68149
- Shop: Dust Cap for Kodiak Disc Brake Kit
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Shop: Trailer Wiring
- Video: Choosing the Right Brake Controller
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Search Results: 25580
- Shop: Brake Controller
- Shop: Cam-Action Lockable Door Latch w/ 36" Pipe for Enclosed Trailers - Zinc Plated Steel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: dust caps
- Shop: Fifth Wheel Hitch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Search Results: dust cap
- Article: Trailer Tire Sizing
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle