Tandem Axle Lift Kit For Double Eye Leaf Spring Suspension Systems

Question

Question:

Is the Lippert tandem axle lift kit available? I can’t find it

asked by: Ron

0

Expert Reply:

While the Lippert Components Tandem Axle Lift Kit is discontinued we do have the Correct Track Trailer Alignment and Lift Kit # RR23QX that will raise your suspension either 1-1/4" or 2-1/4". It will also give you the adjustability to move the axle up to 1/2" forward or back if the axles are out of alignment.

Adding a Wet Bolt Kit # MR58ZR(2-1/4" shackles) or # MR98ZR(3-1/8" shackles) is a great add on when you add the lift kit. The wet bolts help the suspension to travel easier through its range of movement.

expert reply by: Bud M

0

Answer 1

The kit you are looking for is the part #BRKH10B which is nuts and lock washers needed to install the brake assemblies part #AKEBRK-35-SA that you referenced. The nut size is 7/16-20.

view full answer...

Answer 2

Trailer brakes can be either self-adjusting like the Dexter #23-468 or may require periodic manual adjustments like #23-27, depending on the particular model assemblies you have installed on the trailer. An easy way to tell if you have…

view full answer...

Answer 3

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have…

view full answer...

Answer 4

Yes, going from a 4 leaf to a 6 leaf spring would add slightly to your ride height. For example, if the current 4 leaf spring has 3/8" thick leaves, and you go to a 6 leaf spring with 3/8" thick leaves, you would be adding…

view full answer...

Answer 5

Bronze bushings like the #D014-077-00 do not require reaming when installing a shackle bolt into them. The splines in the bolt might make it a little tight but that is on purpose and does not require enlarging.

view full answer...

Answer 6

Thanks for the picture of your build sheet! It does look like the etrailer 6-Leaf Double-Eye Spring item #e94SR you purchased is the correct replacement spring. Feel free to email me back a picture of your suspension but unless you are flipping…

view full answer...

Answer 7

Thanks for the pictures! Since your 2022 Grand Design Reflection 303RLS came with the CRE3000 equalizers you will need three of the MORryde X-Factor Crossmember item #MR33WR. It looks like you have the standard 3" wide frame hanger so all of…

view full answer...

Answer 8

You are doing the right thing by doing the research first. There is a lot of conflicting information out there so let me break it down for you and I will provide some part recommendations at the end. Basically, if you want to tow a 5th wheel trailer,…

view full answer...

Answer 9

The trailer lift kit options really come down to the axle type and setup. For leaf spring axles, you can either flip the axles with a kit like part #K71-384-00 or part #K71-385-00 or you can raise the hangers/shackles with a kit like part #LC425750.…

view full answer...

Answer 10

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Tandem Axle Lift Kit For Double Eye Leaf Spring Suspension Systems

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching