How to Mount Optronics Thin-Line LED Racing Light Kit # LS-108
Question:
Do I take it that I would mount the black bracket you showed the other gentlemen that you measured the center to center hole at 2 3/4inch on the LS 108s and I would pop the LED lights into these black brackets from the front. [Cant see the back mount of the black bracket]. do you guys sell ay other flexible LED lights similar to the 104s or the 108s as I want to mount these just below bumper [kind of in the grill] and the line I want to use has a slight bend and these are straight and will look a little funky[putting 4 in a row per side] with straight lines making a curve. Thanks for your fast response P.S. as they are going on front grill are they quasi waterproof for rain or car washing purposes?
asked by: Mike C
Expert Reply:
The Optronics Thin-Line LED Racing Light Kit, part # LS-108, mounts using included brackets and hardware. The black metal mounting brackets attach to the vehicle with supplied sheet metal screws; the center-to-center spacing of the mounting holes is 2-3/4-inches. The light fixtures themselves attach to the brackets with a Philips screw on each end of the light housing. These decorative lights are not fully waterproof; they have a 2-piece housing that is not permanently sealed but which will provide some degree of resistance to moisture.
If you need a flexible waterproof LED light to fit on the curved mounting surface on your vehicle we do offer several. For example, CIPA offers a 15-inch 9-LED version, part # CM93296. Blue and red LED versions are also available.
Products Referenced in This Question
CIPA EVO Formance Ultrabrights LED Light Strip - Waterproof - 15" Long - White - Qty 1
- LED Strip Lights
- Flexible Light
- Exterior Light
- Interior Light
- Boats
- RV
- Trailers
- Truck Beds
- Hardwired
- 11 - 20 Inch Long
- Cool White
- EVO Formance
more information >
Product Page this Question was Asked From
Optronics ThinLine LED Racing Light Kit w/ Harness and Power Switch - 12 Diodes - Oblong - Qty 2
- LED Strip Lights
- Rigid Light
- Exterior Light
- Hardwired
- 0 - 10 Inch Long
- White
- Optronics
more information >
Continue Researching
- Shop: LED Light Strip Kit w/ Wireless RF Remote Control - 12V or 110V - White - 16' Long
- Shop: Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Shop: CargoSmart Fire Extinguisher Holder for E Track or X Track Systems
- Video: etrailer E-Track Tie Down Ring Review
- Shop: Optronics ThinLine LED Racing Light Kit w/ Harness and Power Switch - 12 Diodes - Oblong - Qty 2
- Shop: CargoSmart Rotating Board Holder for E Track and X Track Systems
- Search Results: 25580
- Shop: Trailer Hitch
- Shop: Grease Seals 10-36 (pair)
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Wiring
- Search Results: e~track
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Brake Controller
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Search Results: fender
- Search Results: equalizer
- Article: Trailer Tire Sizing
- Shop: Fifth Wheel Hitch
- Video: etrailer Enclosed Trailer Transition Plate Review
- Q&A: Is The 1/2" Metal Loom Clamp # A0500 a Single Component Or Multiple Clamps?
- Article: How to Measure for Trailer Hitch Drop
- Shop: Gooseneck Hitch
- Video: Choosing the Right Brake Controller
- Q&A: Can I Upgrade My 3,500 lb Leaf Springs To 5,000 lb Springs If The Measurements Match?
on LED Strip Lights
