Recommended Steering Stabilizer For A 2006 Gulf Stream Conquest BT Cruiser Class C Motorhome

Question

Question:

Ive done quite a bit of research, but cannot pinpoint the correct brackets to use with the RSSC stabilizer. I have a 2006 Gulf Stream Conquest BT Cruiser on a Ford E-450 Chassis with a V-10 motor. Not sure if it has a factory stabilizer. Read one of your customer comments that bought the RBK24 brackets and unit did not have a factory stabilizer, and he had to improvise to use the RBK24 brackets. Turn out the RBK11 were the right ones Thx for your help

asked by: Ken

0

Expert Reply:

I called Roadmaster and confirmed that for a 2006 Gulf Stream Conquest BT Cruiser on a Ford E-450 Chassis the correct steering stabilizer and brackets would be the Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets # RM47MR.

expert reply by: Kevin C

0

Answer 1

Yes, for your 2013 Cambria 27K Class C built on a Ford E450 chassis I have a steering stabilizer that will work for you, which is the following: - Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR

view full answer...

Answer 2

For your 2014 Tiffin Allegro 36LA that has a Ford F-53 Chassis with a V10 engine you would want the part #RM-RBK4-RSSA for a steering stabilizer by Roadmaster.

view full answer...

Answer 3

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 4

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 7

I found the online version of the install instructions for the Exact Center stabilizers like the #RM47MR. What's fun is that just when you think you have found the correct step to address your problem it tells you to continue to the next step.…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Answer 10

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

There is a suspension enhancement option for your 2021 Entegra Vision XL built on a Ford F-53 chassis, but I verified with the manufacturer that the steering stabilizer only fits if you have at least a 24,000 lb GVWR. You're not out of luck…

view full answer...