Replacement Rear Turnbuckle for In-Bed Truck Camper

Question

Question:

I have lost one rear Torklift turnbuckle S9020 on a bumpy road and need to replace. Do you sell one rear turnbuckle?

asked by: Kent S

1

Helpful Expert Reply:

I have a solution for you but the TorkLift AnchorGuard Derringer Turnbuckles item # TLS9020 are not sold individually. You will want to use the Replacement Rear Turnbuckle for HappiJac Qwik-Load Turnbuckle Set item # LC182896 to replace your lost rear turnbuckle. This has a similar adjustable length of 22-1/2"- 35-1/2".

expert reply by: Jerred H

1

Answer 1

You'd be able to reuse the rear tied downs part #TLD3109 on your 2017 Ram 3500, but you'd have to go with the new part #TLD2124 for the front as what was on your old truck will not transfer.

view full answer...

Answer 2

Thanks for the photo, and since your Ford has TorkLift frame-mounted tie-downs that measure 41 inches to the bed, the turnbuckles you will need are going to be from TorkLift. The reason for that is there are no HappiJac turnbuckles that that amount…

view full answer...

Answer 3

We carry frame mounted Torklift camper tie-downs for your 2015 RAM 3500 that would work very well. That is most likely the brand you had on your last truck. Since there are several variations of your vehicle and I would need to know more about your…

view full answer...

Answer 4

Did you try the longer rear hooks in the front position of the #LC182895? If those were long enough they are available separately with #LC182896.

view full answer...

Answer 5

Yes, the TorkLift Custom Frame-Mounted Camper Tie #TLD2131 and the TorkLift Custom Frame-Mounted Camper Tie Downs #TLD3109 are the correct tie downs for your 2017 Ram 3500.

view full answer...

Answer 6

The Curt Trailer Hitch Receiver #C15801 is one of the more affordable options for adding a 2nd receiver to your 2017 Ram 3500. It will sit below and slightly in from the factory receiver. For the camper tie down this is one place where I have to…

view full answer...

Answer 7

Torklift has a set of tie downs for your 2016 Ram 3500 without step boards and a factory hitch with the part #TLD2124 and #TLD3109. You'll need a set of turnbuckles like the #TLS9529-2-LK which would work great as well.

view full answer...

Answer 8

The correct TorkLift tie downs for your 2015 Ram 3500 Crew Cab Short Bed with the cab length running boards are the TorkLift Frame-Mounted Camper Tie Downs - Front #TLD2130 and TorkLift Custom Frame-Mounted Camper Tie-Downs - Rear #TLD3109. These…

view full answer...

Answer 9

I can definitely list out the parts needed to get your 2017 Ram 3500 Dually all set and ready for your Lance Camper. First will be the hitch. For this I highly suggest going with the TorkLift SuperHitch Magnum #TLD1108-30. It will have a max…

view full answer...

Answer 10

Yes, the TorkLift SuperHitch Magnum Trailer Hitch Receiver #TLD1109-30 will fit your 2019 RAM 2500 Power Wagon with the 6-1/2' bed. According to the installation instructions no modification of the spare tire location/support is needed. The…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Rear Turnbuckle for In-Bed Truck Camper

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching