Replacement Hitch Pin for Yakima HoldUp Bike Rack

Question

Question:

I read in an expert reply to a question concerning the difference between Y8890176 and Y8890129 that the expert contacted Yakima and they stated that the two bolts are the same and both will work with an older Yakima Holdup bike rack gray, although he recommends the Y8890176. Will the Y8890176 also work with the newer black Yakima Holdup bike rack?

asked by: Jeff H

0

Expert Reply:

Yes, the Replacement Mounting Hardware for Yakima # Y8890176 will work with your newer black style Yakima HoldUp as long as it is the 1-1/4" shank. If you have the 2" shank version then you would need the Replacement Hitch Bolt and Clip for Yakima # Y8890200.

expert reply by: Scott S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack…

view full answer...

Answer 7

The Tow Defender #RM-4700 you found is really our best option to protect the front of your 2024 Chevrolet Trax. This screen helps to deflect any road debris back down to the ground to keep it traveling under your Trax. This particular cover is…

view full answer...

Answer 8

Thanks for reaching out, Roy! The term "best" can be a little subjective since everyone has their own experiences and needs/wants, but in regards to which bike rack has the best features it is the Thule Epos Bike Rack #TH99XE…

view full answer...

Answer 9

Just looking at your Tern HSD bike with fenders, I'm going to say no the Saris MHS Bike Rack for 1 Bike #SAR23MR is not going to work. I did some research and it looks like a lot of Tern owner's went with the Hollywood Racks Sport…

view full answer...