Weight of 6' X 9' Prest-O-Fit Surface Mate RV Outdoor Rug Kit

Question

Question:

What is the approx weight of this 6x9inch turf mat?

asked by: Les

0

Expert Reply:

The Prest-O-Fit Surface Mate RV Outdoor Rug Kit - 6' x 9' - Gray # PR76ZR weighs only 8 pounds.

expert reply by: Bud M

0

Answer 1

Yes, you can drill holes into the Bulldog Collar-Lok Coupler w/ Low-Profile Latch #BD028288 to install it using the existing mounting hole configuration on your trailer.

view full answer...

Answer 2

Moisture will not seep through the Prest-O-Fit Surface Mate RV Outdoor Rug Kit #PR76ZR. It is waterproof.

view full answer...

Answer 3

Yes, there are trailer couplers that have a greater distance between the center of the coupler where the ball sits to the center of the jack tube hole. However, this is not really by design for this exact purpose and I am not sure it would get you…

view full answer...

Answer 4

I don't think you are doing anything wrong necessarily. There are 2 possible issues that I can think of causing the problem. First, the spring may not be the correct size. A spring that is too short and/or not the correct diameter would fall out.…

view full answer...

Answer 5

As long as your Escape travel trailer is going to always weigh less than 5,000 lbs the Bulldog Collar Lok Coupler part #BD028288 is going to work great as this a very reliable and durable coupler style that's easy to use and will last a long…

view full answer...

Answer 6

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 11

The Global Link RV Entry Door Locking Latch Kit #295-000019 that you referenced would be the correct fit for your 2010 Keystone Montana as this is a fit for standard RV doors like what your Montana has. I attached a review video link for this latch…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...