Will The Replacement Puck Plug Covers Fit 2020 Ram 2500

Question

Question:

Are these products a good fit for a 2020 ram 2500 system?

asked by: David J

0

Expert Reply:

Yes, the Replacement Puck Plug Covers for Elite and Signature Series Fifth Wheel Rails (Qty 2) # 58199 will fit the pucks on your 2020 Ram 2500. If you were also asking about the Rubber Hole Cover for Reese Elite Series Under-Bed Gooseneck Trailer Hitch # RP30136 this will also fit.

expert reply by: Robin H

0

Answer 1

For the four smaller factory holes you need the Replacement Puck Plug Covers for Elite and Signature Series Fifth Wheel Rails (Qty 2) part #58199. These are not round but will work for your 2017 Ram 2500. They came as a two pack so if you want them…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 5

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 6

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...

Answer 7

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...

Answer 8

The Patriot Slider part #BWRVK3270 might be a bit more noisy than the Companion slider part #BWRVK3400 due to the increased number of mounting points, 4 at the corners vs. 1 in the center. Probably not that noticeable and certainly not something…

view full answer...

Answer 9

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 10

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth mentioning…

view full answer...

Answer 11

The B and W Patriot slider is the only hitch unfortunately that can't be adapted to fit the OEM rails of your 2024 Ram 2500 as none of the adapters can work with it. So Mike what that means is that no matter how you slice it...it's time for a…

view full answer...

Answer 12

I recommend using a Lube Plate #16721 over covering the Demco Recon 5th Wheel Trailer Hitch #DM8550043 in Grease #L74FR. The lube plate is much cleaner and you will not have to constantly clean off the dirt and apply new grease over time.

view full answer...

Will The Replacement Puck Plug Covers Fit 2020 Ram 2500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching