Replacement For 15 lb 20 Inch Extended Gas Shock

Question

Question:

I need to replace a gas spring on my camper. Do you still make this one? GS89Z100211BB0067 15 LBS

asked by: Don W

0

Expert Reply:

From what I could find it looks like that gas strut you have is rated for 15 lbs and measures 12" when compressed and 20" when extended. For that the closest option we have is the Gas Shock - 20 lb Force - 20" Extended, 11.41" Compressed # 372-5300-20. This fits on a 10-mm ball socket like your current shock does. If this is part of a set then I do recommend replacing both so that everything runs evenly.

expert reply by: Jon G

0

Answer 1

Thank you for all of the information and pictures! It looks like you should at least have some wiring already run on your 2019 Chevy Express Van 3500 so I'm just as confused as to why you don't have a round plug with a cap inside the…

view full answer...

Answer 2

According to my contact at Timbren, there is a bolt that holds the bump stop in place from above. Once the bolt is removed, the bump stop you described can be slid out of its slot and removed. As long as the weight bearing capacity of the van is not…

view full answer...

Answer 3

A typical RV entry door gas strut ranges from 10-20lbs in pressure. We carry both a 10lbs #372-5300-10 and 20lbs #372-5300-20 that you can use. Really it just comes down to preference and the climate. If you're in a windy climate going heavier…

view full answer...

Answer 4

There are many factors that go into selecting the correct gas shock, the easiest would be to simply match the new shock with the existing using any labels printed on the body. If none are present or you are adding a new one then you can use a formula…

view full answer...

Answer 5

The RV Cabinet Door Struts #37270555 that you mentioned is designed to install to a ball socket like #3691858. However, these cabinet door struts do include the necessary ball socket needed for installation.

view full answer...

Answer 6

There should be a sticker or plate on the pin box itself that lists the manufacturer and model of the pin box. If it is not present then there are some measurements you can take to determine the model of the pin box. I have included a link that…

view full answer...

Answer 7

According to pages 248 and 249 there are no transmission issues when you flat tow your 2011 Ford Flex. If you have a front-wheel drive vehicle it can be flat towed or dolly towed like #RM-2000-1. An all-wheel drive vehicle can be flat towed or…

view full answer...

Answer 8

We do not carry Winnebago or Globrite lights. From what I could find using the numbers you provided, the closest option that we have is the Optronics LED Trailer Tail Light #STL78RPG which is 7-9/16" long x 3-5/16" tall x 3/4" thick.

view full answer...

Answer 9

I went out to our warehouse and pulled the wiring harness. The wire in the Optronics Wishbone 4-way Trailer Harness, #A20WB, is copper.

view full answer...

Replacement For 15 lb 20 Inch Extended Gas Shock

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching