Tekonsha 4-Way Flat T-One Vehicle Wiring Harness For a 2016 Mazda CX-5

Question

Question:

I bought a 4 way trailer harness kit from you guys and Im getting the turn signal and brake signal through the same wire. I have a 2016 mazda cx5 sport.

asked by: Barnum R

0

Expert Reply:

The Tekonsha T-One Vehicle Wiring Harness # 118563 that you installed on your 2016 Mazda CX-5 will convert the 3 wire system that you have on your Mazda to a 2 wire that trailers use. This means that the turn signals and brake lights will both use the same wiring. The 4-way trailer connector has a white wire for ground, brown wire for running lights, green wire for right turn/brake light and yellow wire for left turn/brake light.

I have linked both the installation video and one of our Help Articles below that will help explain the 4-way wiring.

expert reply by: Bud M

0

Answer 1

All of the wiring harnesses available for the 2015 Mazda CX-5 with incandescent lights are going to be fairly similar in terms of installation with one exception; the Curt #C56011 does not have a powered converter so there is no connection to the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 6

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Tekonsha 4-Way Flat T-One Vehicle Wiring Harness For a 2016 Mazda CX-5

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching