B10E-01 Trailer Brake Assembly Replacement Solution

Question

Question:

I have a number off the back plate of a trailer brake assembly that is B10E-01. It also states Axletek-10-GG. Date 6/2006. Left Hand. What is the cheapest replacement for this assembly?

asked by: Ron

0

Expert Reply:

Part number B10E-01 corresponds to Electric Trailer Brake Assembly # AKEBRK-35L. This is most cost effective solution.

expert reply by: Jameson C

0

Answer 1

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 2

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 3

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 4

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 5

The correct replacement seal you'd need for a hub/drum KA90831 which is a 3,500 lb axle is the part #58846.

view full answer...

Answer 6

The Electric Jack w/ Footplate is offered both with the plug part #EJ-3527-BBX and without the plug part #EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the…

view full answer...

Answer 7

We have that size (see link), but none of the tires are radial. They are all bias ply as that is the common construction for the LT tires. The closest tire size that is radial would be the 235/80R16 like part #TTWTRTM2358016E. This size has a section…

view full answer...

Answer 8

Yes. The KA90831 part number you referenced are a 10" x 2-1/4" drum so the #AKEBRK-35R and #AKEBRK-35L would work well for you. If you wanted to upgrade to a self adjusting brake assembly you could use part #AKEBRK-35-SA. These brakes do…

view full answer...

Answer 9

The Nylon Bushing - 7/8" Inner Diameter, 1-1/8" Outer Diameter - 3" Long #TRBU13871 should do the job and press fit into the eye of your leaf spring. Then the Trailer Suspension Bolt #7-260-2 is 4-1/2" long and 7/8" in…

view full answer...

Answer 10

Part number B10E-21 corresponds to Electric Trailer Brake Assembly #AKEBRK-35L. This is the drivers side assembly. Part number B10E-22 corresponds to Electric Trailer Brake Assembly #AKEBRK-35R. This is the passenger side assembly.

view full answer...

B10E-01 Trailer Brake Assembly Replacement Solution

Product Page this Question was Asked From

Continue Researching