Can Swagman Nomad Bike Rack Carry 58 cm Road Bike

Question

Question:

Hi, looking at purchasing item #S36FR which notes it has a Max size bike of 52cm, do you think I can still get a 58cm Road bike on it safely? The bike weighs around 23 lbs. Thank you

asked by: Daniel J

0

Expert Reply:

The Swagman Nomad Bike Rack # S36FR you referenced will work great with a 58 cm road bike. The 52 figure you mentioned is actually the wheelbase max measured in inches that this rack will work with.

expert reply by: Jameson C

0

Answer 1

The Draw-Tite Max-Frame Trailer Hitch Receiver #75673 is what I recommend for you to install on your 2018 Subaru Outback Wagon as it can easily tow a 1,500-lb trailer and hold 2 bikes. You will want to check your owner's manual though about the…

view full answer...

Answer 2

I think your best option is to use theHitch-It 2 Bike Rack for Straight Tongue Trailers #LC731138. This can fit onto your shank or trailer tongue (fits between 2"-3" in diameter) between your vehicle and travel trailer and provides a nice…

view full answer...

Answer 3

At the rear of a trailer or RV the ride quality is very rough when compared to the ride quality at the rear of a passenger vehicle. Reason being the suspension isn't as sophisticated and there is a longer distance between the rear axle and the…

view full answer...

Answer 4

Your best option will be the Swagman Nomad Bike Rack for 2 Bikes - 2" Hitches or RV Bumpers - Frame Mount, part #S36FR, you attached to your question. If your travel trailer's center of the hitch pin hole is less than 11-7/8", you…

view full answer...

Answer 5

There are both Class III and Class IV hitches made for your 2018 Highlander but all are the 2-inch receiver size. The one I recommend for its combination of high capacity, easier installation and value is the etrailer hitch #e98844 which offers…

view full answer...

Answer 6

You have one of the harder setups to find a bike rack for since there aren't as many motorhome-approved bike racks available since the ride is much rougher at the rear of an RV. Since you have fenders that rules out the Escapee since you…

view full answer...

Answer 7

I do have a bike racks that you can potentially use with the Stromberg Carlson Bike Bunk #CC-275. Just for reference, the Thule T2 Pro XTR #TH83JV that you currently use measures 41-1/2" from the center of the hitch pin hole to the farthest edge…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 12

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Can Swagman Nomad Bike Rack Carry 58 cm Road Bike

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching