Height Of The Rhino-Rack Reconn-Deck Overland Truck Bed Rack

Question

Question:

What is the over height of the unit? Rhino-Rack Reconn-Deck Overland Truck Bed Rack - 220 Lbs - 59inch Vortex Crossbars Item # RR56VH looking to see if it will clear the cab or not if i put a kayak or ladder on top. thanks

asked by: Mark C

0

Expert Reply:

The towers of the Rhino-Rack Reconn-Deck Overland Truck Bed Rack Vortex Crossbars # RR56VH are approximately 15" tall with multiple height options giving you less height. Because of this, this rack will not be the correct fit for your 2017 Nissan Titan XD if you're wanting to clear the cab to haul your kayaks or ladders.

Instead I recommend the Thule TracRac SR Sliding Truck Bed Ladder Rack # TH43002XT-501. This ladder rack provides the ultimate in versatility. The towers adjust along the length of your truck bed and easily remove from the T-track base rails. The durable aluminum is lightweight and rustproof and multiple tie-downs are included. One other perk of this ladder rack is that it is compatible with certain inside-of-the-rails tonneau covers so you don't have to choose between a cover or ladder rack.

expert reply by: Kevin C

0

Answer 1

We have several tonneau covers that will fit your 2013 Nissan Frontier crew cab with the 5 foot bed and Utili-Trac system: Access limited edition soft roll up cover, #834532006816 Access Original soft roll up cover, #834532006809 Access Vanish,…

view full answer...

Answer 2

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 3

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 4

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 7

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 8

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Answer 9

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 10

Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with a…

view full answer...

Answer 11

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 12

Hey Brian, the Pace Edwards Full Metal JackRabbit part #PE36CV that you referernced has a 300 lb weight capacity when spread evenly on the cover. The Retrax Pro XR on other hand has a 500 lb capacity.

view full answer...

Height Of The Rhino-Rack Reconn-Deck Overland Truck Bed Rack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching