Fitment of Swagman Traveler XC2 Bike Rack on 2007 Toyota RAV4

Question

Question:

I like the Hollywood rack you’ve recommended but it is not available until the end of April. Would the Swagman xc2 #s64650 work on my 2007 Rav 4 with the exterior spare tire and a Cannondale trail 8 mtb?

asked by: Suzanne M

0

Expert Reply:

The Swagman Traveler XC2 Bike Rack for 2 Bikes, # S64663 has a distance from center of hitch pin hole to the edge of upright arm of 10-1/2". Please compare these measurements against the hitch mounted on your 2007 Toyota Rav4.

expert reply by: Michael R

0

Answer 1

Only certain bike racks are rated for use at the back of an RV or trailer but the Hollywood Racks #HR1400Z bike rack is not one of them. Generally, any rack that can fold or tilt, with few exceptions, won't be rated for this applications. The…

view full answer...

Answer 2

I do have an option for you but you cannot use multiple hitch adapters together like the dual hitch adapter part #D-192 and the hitch extender part #C45791 for example. This would create too weak of a connection point and would limit your towing…

view full answer...

Answer 3

The setup you sent in a picture of is going to have a hitch tongue weight setup reduced by 50 percent. It's the added length added to the hitch and the increased movement that puts leverage and stress on the hitch which is why the capacity is…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 11

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Fitment of Swagman Traveler XC2 Bike Rack on 2007 Toyota RAV4

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching