How Long Will it Take for 10,000 mAh Go Power Portable Power Bank with Solar Panels to Charge

Question

Question:

RE: Go Power Portable Solar Charger Power Bank - GP22RR. Good day, How long does it take for the solar panels to charge the power bank? Thank you for your assistance.

asked by: Tracy

0

Expert Reply:

There are quite a few factors that go into how fast the Go Power Portable Power Bank with Solar Panels # GP22RR will charge, but under really good conditions it could take somewhere in the ballpark of 36 hours. Here are some of the factors you'll want to keep in mind:

- Cleanliness of the solar panel
- Shade on the solar panel
- Time of year
- Time of day
- Orientation to the sun
- Tilt angle to the sun

If you are able to get the best out of these factors then that would be this shorter time frame. With poor sunlight it will take the better part of a day.

expert reply by: Jon G

0

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

Hey Richard, thanks for reaching out! The Air Lift LoadLifter 7500 XL Air Helper Springs #AL57541 does take up the same space as the Curt 19419346 5th wheel bracket kit for your 2024 GMC Sierra 3500. The only way to remedy this is to use the…

view full answer...

Answer 5

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

view full answer...

Answer 6

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 7

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you don't…

view full answer...

Answer 8

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 9

According to my research, AL-KO 8490 references an AL-KO hub for 3,500 lb axles with a 10 x 2-1/4" drum and a 5 on 4-1/2" bolt pattern. For a drum assembly that will work with these hubs I recommend taking a look at the Electric Trailer…

view full answer...

Answer 10

Dexter part 10-41 is a grease seal for a mobile home utility hub. It has a specified inside diameter of 1.938-inches and an outside diameter of 2.523-inches. The nearest match we offer is the Redline part #10-40 which is a single-lip seal that has…

view full answer...

Answer 11

You do not need to remove the bed of your truck to install the HappiJac part #LC182906-182971 that you referenced. I found a copy of the install instructions for this part number (see attached pictures) and there's no mention of the bed needing…

view full answer...

Answer 12

The Dexter brake assembly 023-217-00 is a 10 by 2-1/4 brake for 3,500 pound axles that fits a 4-bolt brake mounting flange. For replacements I recommend part #AKEBRK-35-SA that includes both sides. They're labeld to make the install easier and…

view full answer...

How Long Will it Take for 10,000 mAh Go Power Portable Power Bank with Solar Panels to Charge

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching