Single Crossbar Roof Rack to Install on 2020 Ford F-150 with Ladder Rack

Question

Question:

Hello - We have Yakima roof racks in the bed of the truck - but we need one more flat rack across the cab with the appropriate footings/hardware and ideally, easy to put on and take off. What do we need for that and would you have those parts in stock?

asked by: Mary

0

Expert Reply:

We do have a single crossbar setup that you can add to your 2020 Ford F-150 and it comes from Rhino-Rack with the following parts:

59" Vortex Crossbar - Silver # RRVA150S or Black # RRVA150B
2500 Series Legs - # RRRLKVAH
Fit Kit - # DK427H

This system will be about as easy to install and remove as other roof rack systems and you can install it towards the rear of your cab to essentially extend your ladder rack system.

expert reply by: Jon G

0

Customer Image
(click to enlarge)

Answer 1

I may have a solution for you but if you have the Model 3 roof rack by Tesla on your 2020 Tesla Model 3, then we do not have a channel cover specifically designed to fit your roof rack. If the opening in your roof rack is open then it will cause some…

view full answer...

Answer 2

The closest modern tire size to a 7.00-15 tire is a 225-75-15 like the #AM10256 tire you mentioned. Typically, a 225/75-15 tire will measure about 8-3/4 to 9 inches wide by around 28-1/2 inches in diameter. We offer the same size in a Load Range E as…

view full answer...

Answer 3

The only roof rack options we have for your 2016 Subaru BRZ are ones that require riveting the fit kit to the roof of the vehicle like the Rhino Rack roof rack part numbers #RRVA118B-2, #RRRDM01, #RRRLKVA, and #DK290. This will provide you with aero…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 9

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 10

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...

Single Crossbar Roof Rack to Install on 2020 Ford F-150 with Ladder Rack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching