Recommended Toy Hauler Door Screen For A 2021 Forest River Rogue Vengeance Toy Hauler

Question

Question:

Hi there, I have a 2021 Forest River Rogue Vengeance toy hauler, I measured and it is 97.5 inches from the inside wall to the inside wall. What part number or screen should I order?

asked by: Bryan M

0

Expert Reply:

For your 2021 Forest River Rogue Vengeance Toy Hauler with a 97.5" door width I recommend the LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen - 96-5/8" Wide # 3441409662PBK. The side rails of this screen will easily make up the 1" distance to fit your door opening.

expert reply by: Kevin C

0

Answer 1

The LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen part #3441409662PBK is a universal entry screen for toy hauler trailers which means I would not have any exact advice for your specific application. I am not exactly sure I understand…

view full answer...

Answer 2

I reached out to the manufacturer, LaSalle Bristol, who told me the width measurement is the housing of the screen, so it is the entire unit. They did say the screens are between 1/8" and 1/4" narrower than the size says to account…

view full answer...

Answer 3

The LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen part #3441409662PBK which is 96-5/8" wide is made of a fiberglass mesh similar to a window screen but much more durable. It works to shield from UV rays and bugs while also still…

view full answer...

Answer 4

If you measure just the width of your toy hauler's rear door opening I can determine which LaSalle Bristol CrossBreeze Screen you'd need. The part #3441409775PBK that you referenced is the correct screen if your opening is 97-3/4…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 10

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 11

We do carry the Dometic RV Water Heater #DMC74FR which you could use to replace your Atwood G6A-8E 6 gal RV Water Heater, but I highly recommend switching over to a tankless system like the Furrion RV Tankless Water Heater 60,000 BTU #FR98SR. This…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Recommended Toy Hauler Door Screen For A 2021 Forest River Rogue Vengeance Toy Hauler

Product Page this Question was Asked From

Continue Researching