What Brand of Sealant Is Recommended For Filling Holes After Drilling in RV Roof

Question

Question:

What is the recommended brand and name of the sealant for around and under and on top of the bracket to roof screws. Thanks,

asked by: Guy R

1

Helpful Expert Reply:

The LaSalle Bristol XTRM Universal Self-Leveling Sealant part # 34427034145-1 is what we use whenever we have to drill holes into a trailer and seal them after. It can be used for pretty much anything from roof vents to just general repair. It works very well to keep out water and is really a must to have on hand for trailer owner's.

expert reply by: Conner L

1

Answer 1

To replace just the AC unit I recommend going with the Advent Air as the wiring will just be a plug and play installation: - 13.5K Btu #ACCAR135 - 15K Btu #ACCAR150 These will work with your current distribution panel so everything will fit the same.…

view full answer...

Answer 2

There's won't be much of a difference in decibels when switching air conditioner sizes but there is when switching brands. The quietest units we offer are from Furrion, the Furrion Chill HE RV Air Conditioner System part #FR52PR for 13,500…

view full answer...

Answer 3

Yes, you can replace your Dometic rooftop AC unit (condenser unit) with a Furrion one and still be able to use your existing thermostat and wiring. You just may need an adapter #ACCOLKIT to go from the wiring harness on the Furrion unit to the…

view full answer...

Answer 4

The Furrion Chill HE RV Air Conditioner System #FR92PR does not have a remote thermostat option available for it. We don't have any AC units that have this feature.

view full answer...

Answer 5

I spoke with LaSalle Bristol and they informed me that the LaSalle Bristol XTRM Universal Self-Leveling Sealant part #34427034145-1 has a dry time of around 1 hour.

view full answer...

Answer 6

The LaSalle Bristol XTRM Self-leveling Sealant part #34427034145-1 is very comparable to the Dicor 501LSW self leveling lap sealant. I can't say exactly what the formula is for Dicor but I can tell you that LaSalle Sealant is a silicone sealant…

view full answer...

Answer 7

When installing new Rubber Wiper Seal and Bulb for RV Slide Out, #SR48FR, remove the old adhesive using a putty knife or other tool with an edge to scrap. If you use a metal tool sometimes heating it will assist in the scrapping and removal. The use…

view full answer...

Answer 8

Yes, the Rumber Wheel Chocks part #RM97FR would work well with your 38k motorhome. The size of these will prevent the motorhome from moving and also the chains make them easy to remove and store as well. These are 16 inches long which would easily be…

view full answer...

Answer 9

The Runber #RM74FR tire chocks are big-hulking stoppers that you can depend on. They are made of solid rubber. I can't imagine anything that you could not safely chock with these. There are larger chocks, but they are not solid. The ribbed…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

What Brand of Sealant Is Recommended For Filling Holes After Drilling in RV Roof

Product Page this Question was Asked From

Continue Researching