Troubleshooting Low Voltage Trailer Wiring for 2013 Ford Escape
Question:
I have either part # C56335 or 118566 trailer wiring kit. Went to plug in trailer the other day and got nothing. Checked things over and found fuse was blown. Repalced fuse and still nothing except now I have 9V across all points. Is the control module blown? Is there a way to test that thing? Something else?
asked by: Mark H
Expert Reply:
I do have a way for you to test the wiring on your 2013 Ford Escape and it will be the same whether you have the T-Connector # C56335 or T-One # 118566.
If you've already checked all of your connections and found them to be in proper working order then you'll want to check the control module like what you said. Check the voltage for the wiring going into the module and then coming out of the module to do this. If the voltage is different then the module isn't working correctly and you'll need to replace the wiring. If the voltage is the same then it sounds like the OEM wiring on your Escape isn't working properly and you'll need a shop or dealer to look at it if you don't feel comfortable doing so on your end.
The other thing to keep in mind is that if all of this is happening when you have the trailer plugged in then it would be good to also check the wiring on your trailer and fix any dirty or faulty wiring or connections.
Attached is a wiring troubleshooting help article for you to check out.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: Curt Custom Fit Vehicle Wiring - Trailer Hitch Wiring - C56335 Review
- Shop: Trailer Hitch
- Shop: Power Wire Kit for Electric Trailer Brake Controllers - 12 Gauge
- Shop: Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 5
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Search Results: dw05745~5
- Q&A: Troubleshooting Trailer Wiring that Stopped Working on 2013 Ford Escape, Fuse is Good
- Q&A: Recommended Route for Power Wire on a 2015 Ford Escape with Fuse Panel at the Rear
- Q&A: Recommended Wiring Harness For A 2013 Ford Escape
- Video: etrailer.com Trailer Hitch Installation - 2015 Ford Escape
- Search Results: led load resistor
- Shop: Storage Trunk for Malone MicroSport and XtraLight Trailers - Hard Shell - 3.7 cu ft
- Video: Review of Malone Trailers - Replacement LED Taillight - MAL75YR
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Search Results: 13186
- Q&A: Troubleshooting Running Light Circuit That's Not Active with Malone Trailer and Jeep Grand Cherokee
- Q&A: Troubleshooting Malone Microsport Trailer Left Turn Signal and Brake Light Not Working
- Q&A: Trailer Turn Signals Both Blink at the Same Time When Right or Left Turn Signal is Turned On
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Video: Trailer Hitch Installation - 2013 Ford Escape - Curt
- Search Results: 75758
- Video: Best 2013 Ford Escape Trailer Wiring Options
- Video: Trailer Wiring Harness Installation - 2013 Ford Escape 118566
- Search Results: test
- Search Results: cqt119251
- Search Results: 119251
- Video: Trailer Wiring Harness Installation - 2014 Ford Escape 118566
on Custom Fit Vehicle Wiring
