What is the Height of the SumoSprings Solo Custom Helper Springs # SSR-610-40

Question

Question:

what is the overall height of the sumo bump stops?

asked by: Darrell G

0

Expert Reply:

The overall height of the SumoSprings Solo Custom Helper Springs - Rear Axle # SSR-610-40 is 6 inches. These springs have a weight capacity of 1,000 lbs at 50-percent compression and are made of a durable mircrocellular urethane. They install in place of the factory bump stops.

I have attached a review and installation video for your reference.

expert reply by: Robin H

0

Height of SSR-610-40.
(click to enlarge)

Answer 1

Adding a suspension enhancement system like the SumoSprings #SSR-610-40 that you referenced might help to relieve some of the pressure you are having to put on your weight distribution system, but the actual benefits will be pretty minimal. This is…

view full answer...

Answer 2

It's going to vary some from vehicle to vehicle just because of how your truck rides. However, I reached out to SuperSprings and they told me that a half inch to an inch of clearance between the spring and the frame is fairly standard. The…

view full answer...

Answer 3

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

If your 2014 Toyota Tacoma came with a factory installed 7-Way trailer connector then the plug-in for a brake controller should be there. Harness #3040-P is the correct one for your truck and a Tekonsha brake controller. I recommend the P2 #90885…

view full answer...