Hitch Lock For Thule Camber 4 Bike Rack

Question

Question:

Will this work for a thule 9056 bike rack?

asked by: Naomi

0

Expert Reply:

The Threaded Anti-Rattle Hitch Pin Lock for etrailer Cargo Carriers # e99047 is not a viable option for your Thule Camber 4 Bike Rack # TH9056, however I do have a solution from Thule. The Thule Snug Tite Hitch Lock and Anti-Rattle Device # THSTL2 is exactly what you're looking for and is a guaranteed fit for your Thule Camber Bike Rack.

expert reply by: Bryce D

0

Answer 1

The Thule Snug Tite Hitch Lock #THSTL2 is threaded specifically for the Thule racks listed on its product page. This is the only locking pin offered that is for Thule racks.

view full answer...

Answer 2

Yes, the Thule Snug Tite Hitch Lock and Anti-Rattle Device #THSTL2 is compatible with the Thule Camber 2 Bike Rack #TH9058. All you need to do is thread the hitch bolt through the hitch pin hole and attach the locking mechanism. This is also…

view full answer...

Answer 3

I have the perfect bike rack for your two beach cruiser bikes but because they have fenders and can be heavy you will want to go with a frame mount bike rack that has a higher weight capacity. I recommend the Saris Freedom 2 Bike Platform Rack part…

view full answer...

Answer 4

The best bike rack for your 2018 Subaru Outback will depend on what the distance is from the center of the hitch pin hole to the edge of your rear bumper. I highly recommend the Saris Freedom #SA4412B because at less than 30 lbs it is extremely…

view full answer...

Answer 5

The only time I would recommend the Saris Bones Hitch 4 Bike Rack #SA884 over the Thule Apex XT 4 Bike Rack #TH9025XT is if the weight of the bike rack was the only factor since the Bones weighs 22 lbs while the Apex XT weighs 35 lbs. The Apex XT has…

view full answer...

Answer 6

It sounds like you have a Thule bike rack intended to be used for 2" hitches but only have a 1-1/4" receiver on your SUV's hitch. If you have a 1-1/4" receiver opening you only have a Class I or Class II hitch which is going to…

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

Our lightest 4-bike carrier is the Saris Bones, part #SA884, at 22 lbs. This is an entry-level bike rack with basic features. This bike rack will fit Class II and higher trailer hitches and you can add a hitch lock, #SA3022, and a cable lock, #SA981.…

view full answer...

Answer 9

If the 1-1/4 inch hitch from Mazda is a Class II hitch (for 1-1/4 inch hitches there are Class I and Class II hitches) then it is rated to handle 4 bikes on a rack. But even if it is a Class II an aftermarket Class III hitch with a 2 inch receiver…

view full answer...

Answer 10

The Saris Freedom Bike Rack for 2 Bikes part #SA4412B measures 27" from the center of the hitch pin hole to the outside of the wheel tray. If this does not give you enough room to pull into your garage then you may want to consider a folding…

view full answer...

Answer 11

Both of these Thule racks will do an excellent job of safely and economically hauling four bikes (assuming you aren't using a Class I hitch, which has a manufacturer recommended limit of hauling two bikes at a time). The Camber #TH9056 is lighter…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Hitch Lock For Thule Camber 4 Bike Rack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching