Replacement Lift Arm for Fan-Tastic Roof Vent 2000RDMS 2000RDMS

Question

Question:

I need the lift arm for models 2000RDMS 2000RDMS 2000DMS 2000TRS or 2000TS It is on a 2003 Jayco Designer Legacy fifthwheel RTLS. Paperwork of fan has no parts list bottom of page says 2001-FTVR 3-01?

asked by: Wade B

1

Helpful Expert Reply:

Since the Fan-Tastic roof vent you mentioned has a rounded lid you'd need the replacement lift arm part # FVK8011-05.

expert reply by: Jameson C

1

Answer 1

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 4

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 5

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Answer 6

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 7

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Replacement Lift Arm for Fan-Tastic Roof Vent 2000RDMS 2000RDMS

Product Page this Question was Asked From

Continue Researching