Pre-Mounted Tire Options for the 15 Liger Aluminum Trailer Wheel

Question

Question:

Do you have the Liger wheel as a premounted package ? Power King Towmax Vanguard ST225/75R15 E/10PR

asked by: Greg Z

0

Expert Reply:

We have two pre-mounted combos that will work for you. Take a look at the # LH36FR with the glossy black Liger or the #LH96FR with the gray Liger. These both have the Westlake ST225/75R15 tire already mounted and ready to install upon arrival. I included videos for you to check out.

expert reply by: Conner L

0

Answer 1

I do have an option for you but a lot of the Lionshead Aluminum Wheels are being discontinued like the Wildcat. The only wheels we have from Lionshead in this size are as follows: Liger (Black) part #LH49FR Liger (Gray) part #LH37FR Lynx part…

view full answer...

Answer 2

The Aluminum Lynx Trailer Wheel #LHSL311 is our only 15" diameter Lynx wheel and it is a 6 on 5-1/2" bolt pattern. Here is a list of our aluminum 15"x6" wheels with a 5 on 4-1/2" bolt pattern. Aluminum Sendel Series T07 Black…

view full answer...

Answer 3

The 15" term is in reference to the size wheel that the Provider ST225/75R15 Radial Tire is mounted to. This particular part #A225R6FPS is a tire and wheel combo. The wheel has a 6 on 5-1/2 bolt pattern which is important to know so that your…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Pre-Mounted Tire Options for the 15 Liger Aluminum Trailer Wheel

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching