Can Solera Smart Arm Wind Sensor be Used on More than One Awning

Question

Question:

I have two solera smart awnings on my fifth wheel. Can one wind sensor operate two solera awnings? Or do I have to install two, one for each awning?

asked by: Tom P

0

Expert Reply:

The Solera Smart Arm Wind Sensor Kit # LC715123 that you referenced is designed to only be used on one smart awning. If you had two on your RV you'd need to have two of these sensors.

expert reply by: Jameson C

0

Answer 1

If the awning you have is a 12 volt Solera power awning you can add the wind sensor part #LC715123 but if you have any other awning setup then this would not work and we do not have any other options that would.

view full answer...

Answer 2

The Solera Smart Arm Wind Sensor Kit part #LC715123 is only available for the Solera Smart Arm 12V Power RV Awnings like part #LC405523. It cannot be added to any of the other systems such as the Solera 18V Power RV Awning. The Solera XL Power…

view full answer...

Answer 3

We might have some solutions that would work for you. If your leaf springs are mounted to the UNDERSIDE of your axle beam, the Dexter #K71-385-00 Over/Under Axle Conversion Kit would allow the spring pack to be relocated to the top of the axle.…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 7

We do have what you need, but since your 2022 Winnebago 2529RG is prewired for the Voyager system you will not want to use the Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision #ASA57YR that you were looking at. Because you will…

view full answer...

Answer 8

Thanks so much for the photo, it was super helpful, and what it shows is that your trailer has the Voyager WiSight Pre-Wire Plate. This will allow you to mount the Voyager WiSight camera system: - Voyager WiSight Wireless RV Backup Camera System…

view full answer...

Answer 9

The anti-rattle hitch lock you referenced, part #SHP2040-XL does not carry a weight rating, but it is only compatible with ball mounts that have hollow shanks. Ball mounts with hollow shanks usually have a maximum capacity of 7500 lbs, so 7500 lbs…

view full answer...

Answer 10

One of the things to consider about the tightening knobs on your E-Spec #S94FR is whether the cradle knobs are actually tightening when you turn the knobs to the max. There should be no looseness in the knob and you should be able to press either…

view full answer...

Answer 11

For an e-bike rack for your Letric XP step thru bikes at the rear of an RV the Swagman E-Spec part #S94FR would be a great choice as it's rated for the rougher ride quality at the rear of RVs, has the higher weight capacity needed at 60 lbs per…

view full answer...

Answer 12

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...