Can Pollak 7-Way to 12 Volt Power Outlet Adapter PK11896 be Used on 2021 Ford Ranger

Question

Question:

Will this allow the use of the 7pin as a 12v source For a 12V cooler in newer vehicles with “Smart” trailer connections such as the 2021 Ford Ranger. The 12v lead in the 7pin connector in the Ranger is NOT live until a trailer is connected and the brake is depressed. Does this adapter function as desired under those parameters?

asked by: Grant

0

Expert Reply:

Yes the Pollak 7-Way to 12 Volt Power Outlet Adapter part # PK11896 that you referenced will work on a truck like your 2021 Ford Ranger that has the smart trailer connection. This would simulate a trailer being connected so it would be active.

expert reply by: Jameson C

0

Answer 1

I recommend using a circuit tester like #PTW2993 and test the 12-volt pin, located in the 1 o'clock position on your 7-way connector. Also, check the bottom pin which is the ground circuit. I would also check your vehicle fuse panel and make…

view full answer...

Answer 2

On Ford trucks, they tend to have a "Smart Tow" package which only sends power to the 12 volt pin when the vehicle is in gear. You can verify it by checking if there's power when your truck is in park versus putting the…

view full answer...

Answer 3

You are on the right track. You will need to convert the 4-way to a 7-way so that you can tap into the 12 volt accessory circuit of the connector to power the utility light. For a 7-way with a 4 foot long section of wire you would want the part…

view full answer...

Answer 4

Most if not all trailer wiring harnesses/connectors use larger wires for the 12 volt and ground circuits compared to the other circuits (lights). The sockets themselves don't have an amperage rating so you will go by the draw of the things…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 8

The best air bag kit for your 2022 Ford F-350 that has a single rear wheel axle is the part #F95FV which has the 5,000 lb capacity you are wanting. Firestone bags are superior Air Lift bags. The ply rating of the rubber is higher, the attachment to…

view full answer...

Answer 9

The Torklift Hitch Extension part #TLE1636 that you referenced can tow a trailer that weighs 6,700 lbs like you what you have but you would need to use a weight distribution system with it to have the needed capacity as without a WD system…

view full answer...

Answer 10

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory…

view full answer...

Answer 11

To flat tow your 2023 Ford F-250 you will need the following parts: Tow Bar and Safety Chains - Demco Excali-Bar III Non-Binding Tow Bar item #DM9511013 Base Plate Kit - Demco Classic Base Plate Kit item #DM68FR Wiring Harness - Roadmaster Diode…

view full answer...

Can Pollak 7-Way to 12 Volt Power Outlet Adapter PK11896 be Used on 2021 Ford Ranger

Product Page this Question was Asked From

Continue Researching