Longest Crossbar Roof Rack for 2018 Subaru Outback Wagon with Raised Rails

Question

Question:

Hi, I see that the bar come with the one in 50foot lenghth. 1. can we replace with a longer one since I might need a one that goes at the same with at the mirror? 2. Do you also sell pads for the bar and strap? I need to carry a dinghy boat with the mast on the side. Thanks for your update

asked by: Laurent

0

Expert Reply:

For your 2018 Subaru Outback Wagon the longest crossbar roof rack we is the Malone part # MPG216 which has 58 inch bars and is confirmed as a fit. For a Yakima solution that is longer you could use the # Y00148, # Y00241, and # Y00426 for a 60 inch bar or part # Y00427.

expert reply by: Jameson C

0

Answer 1

Without knowing which Thule setup you currently have on your 2019 Toyota RAV4 I won't be able to tell if you if a certain new setup will be shorter or not. What I can say with certainty is that the Yakima JetStream Crossbars #Y00428, with the…

view full answer...

Answer 2

I understand how it can be overwhelming at first, but that's why I'm here! I do like the Yakima Skyline Towers #Y53TR so definitely get those. The Skyline towers need to mount to what they call a Landing Pad. For your 2021 Toyota Rav4 you…

view full answer...

Answer 3

I attached a picture that shows what the 53 inch long crossbar Wingbar Evo roof rack part numbers #TH711420 and #TH710401 looks like installed. There's a decent amount of overhang that if you wanted to substitute shorter bars like with part…

view full answer...

Answer 4

I attached a picture that shows what the 60 inch long crossbars would look like installed on your 2019 Hyundai Santa Fe. You can see there is quite a bit of overhang on either side of the feet of the rack so a shorter bar would work well. So…

view full answer...

Answer 5

The Landing Pad 23 for Yakima SkyLine and Control Towers - Qty 4 #Y98FR are only compatible with Yakima SkyLine Towers for Yakima Crossbars #Y53TR and the older Yakima Control Towers like the Replacement Yakima Control Tower for Factory-installed…

view full answer...

Answer 6

To mount the Thule Hullavator Pro Kayak Carrier and Lift Assist with Tie-Downs - Side Loading Item #TH898 on your 2021 Toyota Rav4 with flush rails I recommend the Yakima HD Crossbars - Aluminum - Black - 55" Long - Qty 2 Item #Y01156. The…

view full answer...

Answer 7

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 8

Yes, you can use your old Thule crossbars, with no channel underneath the crossbar, and your Thule accessories with the Inno setup. Provided your Thule crossbars are at least 46" and they will not extend beyond the side mirrors of your 2022…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 11

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...