Recommended Weight Distribution System for a Jayco Jay Flight 29BHS

Question

Question:

I have a 2007 jayco flight 29bhs, and Im pulling it with a 2016 f 150. Would the c17062 work for my travel trailer/truck combination, Ive seen specs saying it has 765lbs of tounge weight

asked by: Calvin M

0

Expert Reply:

The Jayco Jay Flight 29BHS has a dry tongue weight rating of 715 lbs. Therefore, the system will need to have a capacity around 800 lbs to account for the trailer while loaded. I recommend the Curt TruTrack Weight Distribution System part # C17500 which has integrated sway control as well as an included pre-torqued hitch ball. If you're looking for a more cost effective option without sway control then the Curt MV Weight Distribution System part # C17062 will work.

The main difference between these two is that the integrated sway control does not require any additional setup nor does it require drilling into the frame. There will also be no need to set the chain tension each time.

expert reply by: Conner L

0

Answer 1

Sorry to hear that, and what you will have to do is set up your Curt Echo Brake Controller #C51180 like it was new. You should be able to scan for the Echo again when setting up, and you will need to enter the 6-digit code, which is found under the…

view full answer...

Answer 2

The 12v hookup wires for the Furrion RV Tankless Water Heater - Gas - Automatic Pilot #FR98SR are going to be the black wire for 12v positive and white for 12v negative. I have also attached a wiring diagram for you to check out as well. It is also…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 6

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 7

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 8

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity don't…

view full answer...

Recommended Weight Distribution System for a Jayco Jay Flight 29BHS

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching