Length of Time Provided by Solar Battery Charge for TireMinder TPMS-TRL-2 TPMS System

Question

Question:

how long does the solar charge last? if I drive at night will the monitor still have enough charge left from the daylight hours?

asked by: Anthony T

0

Expert Reply:

According to my contact at TireMinder, A full battery charge on the TM22138, which we carry as part # TPMS-TRL-2 should last around 36 to 48 hours. As the monitor will automatically go to sleep when not in use, this should allow 1 to 4 weeks of use without sunlight depending on usage.

In case the sun is being uncooperative, a USB charging cable is included if an external power source is needed. You can see a product description video for the product by clicking the provided link.

expert reply by: Mike L

0

Answer 1

A tire pressure monitoring system like the TireMinder Tire Pressure Monitoring System for Brass Valve Stems - 4 Transmitters - Signal Booster #TPMS-APP-4 is great for trailers, however it does not work with water. It will work great for your dry…

view full answer...

Answer 2

Special trailer tires should be inflated to their maximum air pressure. The value for the maximum air pressure should be listed along with the value for the maximum load on the tire's sidewall. These values will usually designate the maximum load…

view full answer...

Answer 3

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 4

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 5

To replace your WFCO WF-8750P power center I recommend the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K. This 2-in-1 AC/DC distribution panel and converter charger keeps your power systems easily…

view full answer...

Answer 6

Basically, a free backing brake assembly like #T4423400, will have one shoe that is shorter than the other and the bracket will be a different shape. On a regular assembly, the shoes will by mirror images of each other. Also, on a free backing…

view full answer...

Answer 7

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

view full answer...

Answer 8

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

view full answer...

Answer 11

You do not want to use a holding tank heater like ThermaHeat #277-000164 on a battery but we do offer battery heaters specifically intended to protect one from extreme cold. You can see all such items on the page I linked for you. You'll want to…

view full answer...

Answer 12

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Length of Time Provided by Solar Battery Charge for TireMinder TPMS-TRL-2 TPMS System

Featured Help Information

Miscellaneous Media

Continue Researching