Troubleshooting an EC Error Code On A Fogatti Tankless Water Heater

Question

Question:

I have the Ec code after 20 seconds after I switch it on. Cant user any other buttons on the controller. I did notice that the is no gas pressure on the test port to the right of the computer board. I do have 11wc going into the unit.

asked by: Mike

0

Expert Reply:

The Fogatti RV Tankless Water Heater # LSB64FR has a cap inside of the gas line hookup on the unit that needs to be removed before attaching the gas line. If you're installing this unit and trying to now run it you most likely still have the gas cap on preventing gas from entering the unit. The EC error code means that it's trying to start the pilot light and isn't able to which would indicate a lack of gas pressure.

expert reply by: Kevin C

0

Answer 1

The first thing I would check on your Fogatti RV Tankless Water Heater #LSB44FR is that the internal gas cap was removed from the gas line input. You'll be able to attach the line with the cap still on so it's something that many others have…

view full answer...

Answer 2

The EC error code mean that the Fogatti Tankless Water Heater #LSB64FR tried to start the pilot light and was unable to due to low gas pressure. You'll want to have a licensed technician check to ensure you have 11"WC at the unit. If you…

view full answer...

Answer 3

When you are getting an "EC" error code on a Fogatti tankless water heater like your FS08B or the #LSB44FR, it is due to the pilot light trying to ignite but could not due to low gas pressure. Since you have checked the gas flow and are…

view full answer...

Answer 4

If the ignitor isn't actually lighting up on your Fogatti Tankless Water Heater then either the propane isn't at the correct pressure or the ignitor is bad. I would start by having a technician check the gas pressure to ensure you're…

view full answer...

Answer 5

On a Fogatti RV Tankless Water Heater #LSB64FR an E0 error means that the outlet temperature probe is open or shorted and EC means that there is a communication error between the thermostat/controller and the unit. I recommend first checking your…

view full answer...

Answer 6

I can help you get the bearings and seal you need, but I need some information from you on your bearings. You will need to pull one of your hubs and look at the bearing number on the face of the inner and the outer bearing of your hub as well as the…

view full answer...

Answer 7

Hi Ron; the K-Source Snap & Zap Custom Towing Mirrors #KS48NQ aren't available yet as of May 2024 and we don't have an exact ETA. They are available for pre-order so if you order them now you can get them as soon as they are in stock.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Thanks for reaching out, Matt! The Replacement ECU Service Pack #F69VV is for single-path applications. Since you have a dual-path kit you'll need the Replacement Dual-Path ECU Service Pack #F58VV instead. This is designed for the newer F4 kits…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Troubleshooting an EC Error Code On A Fogatti Tankless Water Heater

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching