Bike Rack Solution for 2017 Honda Civic SI with Spoiler

Question

Question:

Will this trunk mount work on a 2 Door Honda Civic Si with a fin across the trunk?

asked by: Kerri

0

Expert Reply:

I wish we had a trunk rack that fit your vehicle but we don't have any due to the spoiler. Only option might be a roof rack like the Inno Aero Roof Rack # INXB130-2, # INXS250, and # INK683 and then you could use a roof rack like the Malone Pilot part # MPG2103.

expert reply by: Jameson C

0

Answer 1

Sounds like what you need is a roof rack system and a kayak carrier for your 2017 Honda Civic SI Coupe. For the roof rack, my best recommendation for your 2017 Honda Civic SI Coupe is an Inno Roof Rack System with parts #INXB108-2, #INXS200, and…

view full answer...

Answer 2

The Inno Aero Crossbar System part #INXB108-115, part #INXS200, and part #INK642 is a great cost effective option for a 2015 Honda Civic Coupe and what I recommend using. In fact, it is the most cost effective option we have with the aero shaped…

view full answer...

Answer 3

For your 2019 Honda Civic Coupe we have roof rack fits from Inno and I recommend using the aero crossbars as they look better and do a better job at reducing wind noise and drag than the square crossbars. Here are the parts you'll need: 54"…

view full answer...

Answer 4

They are compatible! The Swagman bike rack you asked about will absolutely work with the Inno crossbars and roof rack that fit your 2019 Honda Civic coupe. The exact parts you need for your Civic are the following: - Inno Aero Crossbars #INXB108-2 -…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 8

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 9

Hey Alec, For your 2016 Ford Fusion I recommend the recommend a roof rack from Inno: Inno Aero Crossbars #INXB138-145 Inno Through Feet for Aero Crossbars #INXS250 Custom Fit Kit for Inno XS200, XS250, and INSU-K5 Roof Rack Feet #INK860 As with any…

view full answer...

Answer 10

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Yes, the Roamer LT Roof Rack for Pop-Up Campers and Camper Shells #S80510 will fit your 2023 Forest River Flagstaff 176LTD. It is also what I recommend to add a roof rack for a bicycle carrier on your camper. Once installed you will be able to add…

view full answer...