Recommended Motor For Replacement Gearbox for Venture Aluminum Electric 5th Wheel

Question

Question:

What would be the best motor to pair with the LC276602.

asked by: David W

0

Expert Reply:

I recommend the Lippert Venture 5th Wheel RV Landing Gear Motor part # LC142178. This motor is designed to work with the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies, part # LC276602. It has a rated load of 5000lbs total for two legs single motor and 8,000 lbs, or 4,000 lbs each leg dual motor.

I have included product description links and video review links below.

expert reply by: Mark Smith

0

Answer 1

Yes, I attached a diagram you can use to install the #LC146059 that you referenced.

view full answer...

Answer 2

Thanks for the pictures. You won't need to replace the entire landing gear set. For your Venture landing gear on your 2002 Forest River Cedar Creek Fifth Wheel you will want item #LC119102 for the lead leg or item #LC119101 for the follow leg.…

view full answer...

Answer 3

Yes, for your Venture VMC900R lead leg jack the part #LC146059 is the correct repair kit.

view full answer...

Answer 4

Yes, based on the picture you sent in the replacement gearbox part #LC276602 that you referenced is the correct replacement. This is aluminum too which means it will be a bit stronger as well.

view full answer...

Answer 5

It's probably time for a new motor and gear box like you suspected. The part #LC276602 that you referenced is the correct gear box and then for a motor #LC196308 and you'd be set.

view full answer...

Answer 6

Yes, the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies #LC276602 is a great replacement product for most 5th wheel factory landing gear as it works with Atwood, Lippert, and Stromberg-Carlson landing gear.…

view full answer...

Answer 7

I went out to the warehouse to measure replacement gear box #LC276602. From the base of the gear box to the end of the shaft on the output side it is 4.75 inches. From the end of the shaft to the center of the pin is 1.35 inches. The diameter of the…

view full answer...

Answer 8

Yes, there is 15 teeth per each gear on the Replacement Gear Kit for etrailer and Ram Sidewind Jacks #TJA-2000S-GR. These gears have a thickness of 0.5", an OD of 1.36", and an ID of 0.5".

view full answer...

Answer 9

The #LG-217884 landing gear motor you referenced is indeed compatible with your industry-standard Venture landing gear, per Stromberg Carlson. The spark-free switch assembly is safe for use around propane bottles.

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...