Trailer Hitch Receiver For a 2021 Volvo XC60 Recharge Plug In Hybrid

Question

Question:

Does the C92WR work on a 2021 Volvo XC60 Plug-in Hybrid? Thanks

asked by: Ralph

0

Expert Reply:

Yes, the Curt Trailer Hitch Receiver # C92WR is confirmed to fit your 2021 Volvo XC60 Recharge plug in hybrid. This has been confirmed by Curt. This receiver is rated for a maximum of 400lbs of tongue weight and 4,000lbs total trailer weight. Be sure to check with your Volvo dealer for the exact specifications for your vehicle.

expert reply by: Bud M

0

Answer 1

I can confirm that both the Curt Trailer Hitch Receiver item #C92WR and the Curt Vehicle Wiring Harness item #C59236 fit your 2022 VolvoXC 60 recharge plug in hybrid. This hitch is custom fit and bolts directly to your Volvo with included hardware.…

view full answer...

Answer 2

The Curt #C92WR Trailer Hitch can cause issues with the lift gate sensors, but with the sensor being off center, said interference should be less than one that would be at the center point. With the 2 inch receiver opening on this hitch, it would be…

view full answer...

Answer 3

The installation for the Curt Trailer Hitch Receiver #C92WR on your 2022 Volvo XC 60 Recharge will be the same as the 2021. The exhaust is in the same location they simply use a turn down exhaust tip versus the rear exit. The bumper fascia and heat…

view full answer...

Answer 4

Yes, the Curt Trailer Hitch Receiver #C92WR is confirmed by Curt to Fit all trims of the 2022 Volvo XC60 including your recharge hybrid. I recommend installing the Wiring Harness #C59236 when you install the receiver. This 4-way connector will allow…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

To add a hitch to your 2024 Toyota RAV4, I recommend the etrailer item #e23ZR. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a 4,000 lbs towing capacity, and a 600…

view full answer...

Answer 12

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...