What Is The Distance From Center Of Mounting Hole To End Of Bracket On Sleeve-Lock Coupler CTA-196?

Question

Question:

What is the measurement from the center of the mounting hole to the backside edge of the mounting bracket on item CTA-196?

asked by: Noah P

0

Expert Reply:

I would be happy to help!

From the center of the mounting holes on the Sleeve-Lock Trailer Coupler - Adjustable Channel Mount - Black - 2" Ball - 7,000 lbs # CTA-196 to the end of the mounting bracket measures 3/4" as shown in the included diagram.

I included a video of the # CTA-196 for you to take a look at.

expert reply by: Samuel C

0

Dimension Of Sleeve-Lock Coupler # CTA-196
(click to enlarge)

Answer 1

I reached out to Marlboro Manufacturing and found that the load carrying capacity of the Weld-On Hinge w/ Brass Bushing and Grease Zerk #MA89ZR is 576 lbs.

view full answer...

Answer 2

The weight capacity of the Weld-On Hinge w/ Brass Bushing and Grease Zerk #MA39ZR is 216 lbs.

view full answer...

Answer 3

Yes, the Sleeve-Lock Trailer Coupler #CTA-196 will fit the channel bracket that comes with the Brophy Lunette Ring w/ 3-Position Adjustable Channel Bracket #BR43ZR. The bolt holes match as well when it comes to size and spacing so you'll be good…

view full answer...

Answer 4

When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down until…

view full answer...

Answer 5

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 6

The Dexter Electric Trailer Brake Kit #23-105-106 are a replacement set for the 023-358-00. This kit includes a right and left brake assembly that is manually adjustable. I recommend the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as…

view full answer...

Answer 7

It sounds like your current 7-way is attached to the factory hitch of your 2014 Ford F-250 that you will be replacing with the Curt #C14355 and are looking for a way to relocate the 7-way. One solution would be the part #PK12711U that you referenced…

view full answer...

Answer 8

I have a solution for you, however I was able to get in contact with the vendor and this wheel is No Longer Available. We are able to ship you the Aluminum Liger Trailer Wheel - 16" x 6" Rim - 8 on 6-1/2 - Black #LH39FR or if you need the…

view full answer...

Answer 9

Yes the pipe diameters of the #BDPG9810-00 and the #TJDP-7000S-B are the same. Both of them have a 2 inch inner diameter and a 2-1/2 inch outer diameter.

view full answer...