What Would Cause MaxxAir RV Roof Vent to have Green Blinking Light and Stop Working

Question

Question:

purchased a maxair 6200k for a custom toyhauler build. first time powering it up it runs a few second and stop with green light blinking. ive read some about this issue and havent resolved it yet. what are your suggestions thanks

asked by: Brant T

0

Expert Reply:

The blinking green light of a Maxxair roof vent means that the voltage the vent is seeing on it's power circuit is outside of what it will work with. My guess is your toy hauler has a battery with low voltage which is causing the issue so that's where I would start.

expert reply by: Jameson C

0

Answer 1

The Progressive Dynamics #PD4560K18LS8 is a power center which includes a converter/charger for lead acid or lithium batteries. The converter control board has a tiny switch on it that can be set to "LI" for lithium or…

view full answer...

Answer 2

The American CS6000XL that you referenced is no longer available and there isn't a direct replacement for it but the closest solution as a replacement would be the Progressive Dynamics RV Control Center part #PD4560K18LS8 which as the same…

view full answer...

Answer 3

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover,…

view full answer...

Answer 4

According to what Progressive Dynamics recommends, the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8 is the correct replacement for your WFCO WF-9960 converter.

view full answer...

Answer 5

Since the part #PD4655V has come out and has ability to switch between lithium and lead acid batteries the part PD4655LIV was discontinued. At one point there were separate parts for lithium and lead acid batteries but since the current one can do…

view full answer...

Answer 6

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion…

view full answer...

Answer 7

The Progressive Dynamics Replacement Section #PD4655V does have a jumper to change the charging profile to lithium compatible. You'll simply need to move the black jumper over from the WIZ side to the LI side.

view full answer...

Answer 8

Great question Larry, so the current version of the Progressive Dynamics converter #PD4655V does support lithium batteries as-is. At one point it did not but since lithium batteries have become more popular Progressive Dynamics decided to make this…

view full answer...

Answer 9

For your Parallax 555 model there isn't a converter replacement available. You'd have to replace the entire panel with the part #PD4560K18LS8. It does not come with breakers but in manual all of the required ones are listed from…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 12

Short answer, yes you can convert from 30amp to 50 amp. It will be costly and require an electrician. Long answer, you will need to replace the power outlet with SmartPlug RV and Marine Power Inlet - 50 Amp - Stainless Steel #SM79FR. Then replace…

view full answer...