Mounting Kits For Base Plates With No Accessory Brackets

Question

Question:

I PURCHACED A CURT BASE PLATE FOR MY 2021 CHEVY EQUINOX. ORDER # 111657535. IT DOES NOT HAVE MOUNTS FOR ELECTRICAL CONNECTOR, BREAK AWAY SWITCH AND AIR FITTING FOR AIR BRAKES. DO YOU HAVE ANY SUGETTIONS? THANK YOU.

asked by: GARY S

0

Expert Reply:

Since the Curt Custom Base Plate Kit - Removable Arms Item # C28FR doesn't come with brackets to attach the needed mounts to you can use the No-Drill Mount for Electrical Mounting Bracket - Short # 18140 or No-Drill Mount Bracket, Long Item # 18136. I've attached videos to help you with installation.

expert reply by: Kevin C

0

Answer 1

Yes, the Curt 70108 base plate kit #C28FR that fits your 2022 Chevy Equinox does work with models that have the lower shutters.

view full answer...

Answer 2

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 3

There isn't a lower channel cover for the Malone roof rack part #MPG216 that you referenced. There is a strip on the top of the bar designed to help prevent noise but there isn't a strip for the bottom of the bar. We haven't had any…

view full answer...

Answer 4

I reached out to Malone, who said the Replacement Rubber Strip for Malone AirFlow2 Roof Rack Crossbars - Bottom - 50" Long #MAL43TR is 20mm wide overall, and fits a t-slot (the indent on the left and right) that is 15mm wide.

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 11

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Mounting Kits For Base Plates With No Accessory Brackets

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching