Does Solera Awning Fabric Fit Dometic Awning

Question

Question:

Will this awning fabric replacement work with a Dometic 9100 Electric awning?

asked by: David

0

Expert Reply:

Yes the Solera awning fabric part # LCV000334417 does work with the Dometic 9100 electric awning that you have.

expert reply by: Jameson C

0

Answer 1

Yes. You've found the right part. The 29/324 378 part number you've referred to off your existing jack corresponds to the Lippert Replacement Level Up Hydraulic Jack - 8,000 lbs - 15" Travel #LC26FR so it will be the correct replacement…

view full answer...

Answer 2

Only solution would be with a new leg like part #LC26FR as the seal for your jack is not available.

view full answer...

Answer 3

The Solera 19' Replacement Awning Fabric is compatible with your Dometic A&E awning. This has a heavy-duty 13.5-oz vinyl fabric construction and comes with a 5-year warranty. We have the following colors available: -Black Fade #LCV000334424…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...