Where is Brake Controller Install Port on 2014 Lincoln Navigator

Question

Question:

Where is the brake controller port on a 2014 Lincoln Navigator

asked by: Don B

0

Expert Reply:

The brake controller install port for the # 3034-P that fits your 2014 Lincoln Navigator is located behind the dash panel like you can see in the attached picture.

This would allow you to install and use our very reliable and great performing Brake Evn # TK63VR.

expert reply by: Jameson C

0

Port Location
(click to enlarge)

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 4

The first thing you will need for your 1999 D250 is a 4-way. The Curt T-Connector Vehicle Wiring Harness #C55317 plugs into the connection points behind your rear bumper and will allow you to power your trailer's signal lights. Once the 4-way is…

view full answer...

Answer 5

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 6

I do have a solution for your 2024 Kia Telluride that has the LED taillights that does allow it to have both a 4-way and 7-way plus install a brake controller but it is not with the #TK74CR which does not work for you based on the LED taillights.…

view full answer...

Answer 7

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Answer 8

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 9

Hey Scott, If you're wanting a brake controller that will plug into your factory wiring harness and won't give you any errors then I recommend going with the Tekonsha Prodigy P3 #90195 along with the Tekonsha Plug-In Wiring Adapter #3034-P.…

view full answer...

Where is Brake Controller Install Port on 2014 Lincoln Navigator

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching