Does the Phoenix USA Rear Wheel Center Cap Fit a 22.5" Alcoa Rim

Question

Question:

Does this cover fit a 22.5 Alcoa rim

asked by: James H

0

Expert Reply:

The Phoenix USA Rear Wheel Center Cap, part # PXQ1020L, fits 8-1/4" hubs and 8 on 275mm bolt patterns. If these match the specs on your rim, this will fit.

It looks like there are several bolt patterns available for the 22.5" Alcoa rims. If you let me know the bolt pattern, I can tell you definitely if this will work for you or recommend a different one if it doesn't. I've linked to an article we've written to help you measure your bolt pattern.

expert reply by: Kef G

0

Answer 1

The Phoenix USA Wheel Center Cap part #PXQ2010 has right hand threads (threads run clockwise) but that does not mean there is a left and right hand cap. You will need to check the bracket of your existing cap to see if there is a L at the end of…

view full answer...

Answer 2

I have a possible solution for you, but the Replacement Phoenix USA Rear Wheel Center Cap #PXPH1764 is actually designed to be used on 10 lug applications, not 8 lug. It sounds like Replacement Phoenix USA Rear Wheel Center Cap - 6-1/2" or…

view full answer...

Answer 3

The Phoenix USA Wheel Center Cap part #PXPH1843 is a replacement for the Phoenix USA Wheel Center Cap part #PXQ1009 which is for a 6-1/2" diameter axle or the Phoenix USA Wheel Center Cap part #PXQ1020 which is for a 8-1/4" diameter axle.…

view full answer...

Answer 4

The Phoenix USA Rear Wheel Center Cap - 8-1/4" Hub Diameter - Center Hole Mount - Right Thread #PXQ2020XL fits the rear motorhome wheels that has a hub diameter of 8-1/4 inches and a bolt pattern of 10 on 285 millimeters. When it comes to the…

view full answer...

Answer 5

The Phoenix USA Wheel Center Cap part #PXQ1009 which is for a 6-1/2" diameter axle or the Phoenix USA Wheel Center Cap part #PXQ1020 which is for a 8-1/4" diameter axle already comes with the bolt and bracket that is needed but these are…

view full answer...

Answer 6

Even though most threads on bolts use right-handed bolts/nuts, some special scenarios warrant a left-handed thread. When wheel accessories like the Phoenix USA Rear Wheel Center Cap - 8-1/4" Hub Diameter - Center Hole Mount - Left Thread…

view full answer...

Answer 7

I spoke to my contact at Phoenix USA and he told me the correct part for your 2007 Winnebago Tour 40TD Motorhome is the Replacement Right Thread Mounting Bracket for Phoenix USA Wheel Center Caps for 8-1/4" Axles #PHX67FR.

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...