Are There Wheel Center Caps For 2-3/4" Pilot Diameter?

Question

Question:

what size center wheel caps do I need my center hole in wheel measures 2 3/4

asked by: Ken

0

Expert Reply:

The closest wheel center caps we have to 2-3/4" is the Americana Trailer Wheel Center Cap - Chrome Plated - 2.80" to 2.84" Pilot # AM90113. This is for 2.80" - 2.84" diameter hole and it fits 12" or 13" wheels. If you measure again and you in fact have a 2-3/4" hole then this likely won't work for you and you will want to contact the manufacturer of the wheel to determine if you can get wheel center caps.

expert reply by: Andrew N

0

Answer 1

If the center part of the hubs on your trailer are 2-1/2 inches or smaller then tire and wheel combo #AM30120 will fit. A pilot hole can be larger than the hub center diameter if the wheel is held on to the hub with lug nuts. But if it attaches using…

view full answer...

Answer 2

The bearing part #L44649 has an inner diameter of 1.063 and is typically used in 3,500 lb axle hubs and the #L44643 has an inner diameter of 1 inch and is typically used on 2,000 lb axle hubs. If you can get me more info on your trailer like axle…

view full answer...

Answer 3

If the hub that was on your trailer axle previously had 8-91A stamped on the back of it your spindle should require inner and outer bearings of #L44649 like you used. The part #8-91-05UC1 SHOULD be an exact replacement. However we need to double…

view full answer...

Answer 4

Yes, the Dexter Trailer Idler Hub Assembly part #8-91-05UC1 will work with the bearing part #L44643 and the race part #L44610. They both have a 1.980" outer diameter which is why they are compatible with the above trailer hub. As long as your…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Are There Wheel Center Caps For 2-3/4" Pilot Diameter?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching