Will Solera Replacement Awning Fabric Fit Dometic

Question

Question:

Does your fabric replacement fit dometic awnings with existing alumaguard?

asked by: Neal O

0

Expert Reply:

Yes the Solera replacement awning fabric part # LCV000334420 would fit your Dometic setup that you currently have that has the alumaguard.

expert reply by: Jameson C

0

Answer 1

Your Weatherpro awning is made by Dometic, but the Solera fabrics that we offer would still be compatible. Based on the code I believe you have a 21' awning. I would doublecheck this by measuring from the center of one arm to the center of the…

view full answer...

Answer 2

We checked with Dexter and P-21 just indicates where the axle was made. With the serial number we could track down more info on your axle. However, in the mean time you could pretty easily get the bearing numbers off of your current bearings and then…

view full answer...

Answer 3

Took some doing but I was able to track down the correct bearing kit for your Sundowner horse trailer with 7,000 lb axles, and what you will need is the following: - Bearing Kit, 14125A/ 25580 Bearings #BK3-200

view full answer...

Answer 4

The #RG06-070 grease seal included with the #BKS-200 bearing kit is .375 or 3/8 of an inch thick. The corresponding race to the 14125A bearing is a 14276 which has an outside diameter of 2.717 inches. The 25520 race is used with the 25580 bearing,…

view full answer...

Answer 5

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 9

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

Sorry Jennifer, I am a bit confused as you were looking at the Replacement U-Clamp Bracket #RM-B141 which mounts with bolts and not U-bolts. This part works with the Split Bushing #RM-205217-10 for the discontinued Roadmaster Front Anti-Sway Bar…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...