Do You Have Any Yakima Roof Tracks Available to Fir my Yakima Roof Rack?  

The only way to install the Yakima 60" HD Tracks for Roof Racks, OverHaul HD, and OutPost HD #Y74MR is with drilling. We do not have a different way to install these.

We have a few systems that will fit the factory tracks on your 2018 Mercedes-Benz Sprinter. If you want the 2 Crossbar system, I recommend the following: Rhino-Rack Vortex Aero Crossbars - 71" Long - Qty 2 #RRVA180B-2 Quick Mount Legs - RTC…

We have not test fit the Yakima 60" HD Tracks for Roof Racks, OverHaul HD, and OutPost HD #Y74MR on a 2022 Chevy Silverado. That said, they do have wiggle room for positioning, and the cap nuts on the underside are just a 1-1/4" in diameter…

The channel on the Rhino Rack Roof Track, part #RRRTV148 is 0.86 inches (a little less than 7/8 inches) by 0.19 inches (a little less than 3/16ths inch). I've included a diagram showing these dimensions. The upper channel is about 5/8 inches…

The Yakima 60" HD Tracks for Roof Racks #Y74MR was designed to be used on truck bed rails or truck bed caps. It was not intended for use on the roof of a vehicle. That being said, it does not mean that you cannot do it. It simply means that…

The Replacement PlusNut Hardware Kit, part #Y8880039 you asked about are 10-32 mm with a thread pitch of .75 inch according to our contact at Yakima.

I spoke to my contact at Yakima and unfortunately they were not able to inform me of the pull strength rating of the Replacement PlusNut Hardware Kit for Yakima Roof Rack Tracks part #Y8880039. The reason this number is not readily available is…

You can add the Yakima Tracks for Roof Racks, which come in 60" #Y01135, 54" #Y01127 or 42" #Y01126 to your 2015 Ford F-150 although I could not tell from the photo if there was a space between the truck cap and the roof of your truck.…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…