Troubleshooting MaxxFan Plus Roof Vent

Question

Question:

Fan will work and then it wont turn on or open

asked by: Jim B

0

Expert Reply:

Check your power source, ensure you have voltage to your MaxxFan, MA00-04000K. Use a voltmeter to ensure your battery is delivering the required voltage (no less than 11-volts). If this is a new install please verify that you connected wiring correctly, incorrect polarity will cause problems. Make sure the white wire is grounded and the black wire is connected to your 12V power source of at least 5-amps.

expert reply by: Michael R

0

Answer 1

The replacement vent cover for your Sundowner horse trailer can be different as vents are often changed over the years by manufacturers. The vent cutouts remain consistent because there is an industry standard size so replacements are available but…

view full answer...

Answer 2

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Answer 3

The switch on your wall is only turning the power on and off for the fan. With a powered lift there wouldn't really be a way to tap into the function and wire it to a switch to make it easier to access. The only option would be to replace the…

view full answer...

Answer 4

When your Lippert Ground Control 3.0 #LC358590 has a reading that says "Comm Error" it is referring to the communication between the controller and touch pad. You will need to check your harness to ensure it is connected properly and there…

view full answer...

Answer 5

When installing the Replacement Fan Motor Assembly Kit for Fan-Tastic Vent Roof Vent Fans #FVK8017-00 you can remove the fan housing if you like, and this will be easier if done from the top of the roof as opposed to inside the trailer. I have added…

view full answer...

Answer 6

Based on what you described wanting the MaxxAir MaxxFan part #MA00-04751KSX is your best option. This has a 4 speed fan, a powered lift, and has no thermostat. I attached a review video for this for more info as well.

view full answer...

Answer 7

Sure thing! The MaxxFan Roof Vent w/ 12V Fan #MA00A04301K is actually exhaust only. However, if you're wanting the exhaust & intake version, then you'll want the: -MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat #MA00-04000K.

view full answer...

Answer 8

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 11

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Troubleshooting MaxxFan Plus Roof Vent

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching