Replacement Motor for Johnson Vent Hood

Question

Question:

I have a Johnson range hood fan motor, model hc660gdD10a. Do you have a replacement motor?

asked by: Bob A

0

Expert Reply:

Unfortunately, I wasn't able to find anything online regarding a replacement for that motor. You'll probably be best off contacting Johnson Supply directly to see if they can recommend a replacement for you.

Another option if you can't locate the correct motor would be to replace the existing hood. We offer 12-volt RV range hoods in 20, 22, 24, or in 23-5/8 inch widths. You can see our selection by using the provided link.

expert reply by: Mike L

0

Answer 1

The Camco Water Heater Element #CAM02143 is what you need for the SW6DEL water heater. According to our research this element will replace the heating element perfectly in your Suburban water heater. You can also use the Camco RV Water Heater Anode…

view full answer...

Answer 2

Motor #BVD0218-00 would be the correct replacement for what you have. The motor comes with new wires, a bracket, and hardware. If you needed the fan blade you would also want the part #BVD0215-00 and for the switch part #BL0108-00.

view full answer...

Answer 3

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 4

LaSalle Bristol RV Plumbing Roof Vent #34474558B is made to fit on RV pipes with an outside diameter of 1-1/4-inches or 1-1/2-inches. The actual hole diameter through which the RV vent pipe will extend measures 1-7/8-inches as shown in the photo I…

view full answer...

Answer 5

Did you pull any fuses or disconnect the battery before installing the Replacement Hydraulic Pump for Lippert Level Up Leveling Systems #LC58TF Vic? Have you tried unplugging and replugging the connector back in to see if a pin needed to be reseated?…

view full answer...

Answer 6

The rule of thumb here in most cases is, the smoother the surface and glossier the paint, the shorter the nap. With the roof of the trailer being fairly smooth a 3/4" or less nap would be the better option. The manufacturer recommends a…

view full answer...

Answer 7

Hi Christopher, There unfortunately isn't a guide to tell us the exact part numbers for the vents, skylights, etc. on your Passport. We offer a variety of plumbing vents and 12v fan vents but we unfortunately do not offer skylights. If you want…

view full answer...

Answer 8

Your current Greystone Fireplace WF2613R is a 26 inch wide curved fireplace which can easily be replaced with the Greystone 26" Electric Fireplace with Crystals - Recessed Mount #324-000069 as this is the same size. Install would not be…

view full answer...

Answer 9

The piece you're referring to in the #LC26VR kit is called a "shoe". This part is plastic with foam pads on each end that helps cushion the motor bracket as it slides back and forth to either end of the track.

view full answer...

Answer 10

If you look at the photo I edited for you, you will be able to see all the dimensions of the mounting tabs on the top of the Ultra-Fab #UF48-979006 Scissor Jack.

view full answer...