5th Wheel/Gooseneck 7-Way Wiring Kit for Accessing Just Reverse Light Circuit

Question

Question:

I am looking for an odd plug. I am attaching a link to the Magnum truck rack page. I am looking to tie in my aux backup lights in an easy way. Do you have something similar? It does not need to be 10ft. Thank you for any help you can send along.

asked by: Jeffrey L

1

Helpful Expert Reply:

I checked out the link you attached and the easiest solution we have that's similar is the part # 41157 which is a 5th /gooseneck wiring kit that you could use as a way to get just the reverse light circuit.

expert reply by: Jameson C

1

Answer 1

The red wire in the picture you submitted is the 12 volt charge circuit that is charging the battery. The white is the ground and the blue is brake output.

view full answer...

Answer 2

Most if not all trailer wiring harnesses/connectors use larger wires for the 12 volt and ground circuits compared to the other circuits (lights). The sockets themselves don't have an amperage rating so you will go by the draw of the things…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

Thanks for the photo, that was a big help. And the answer is yes, your 2023 Ford F-350 Cab & Chassis is 100 percent compatible with the Curt 7-way: - Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector #C69CR…

view full answer...

Answer 10

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 11

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over 15%…

view full answer...

Answer 12

Hi Mike, good question so I checked directly with Firestone for you and can verify that yes, the Ride-Rite air springs you asked about do fit the 2024 Chevy Silverado 2500 ZR2. The correct part number is the following: - Firestone Ride-Rite Air…

view full answer...

5th Wheel/Gooseneck 7-Way Wiring Kit for Accessing Just Reverse Light Circuit

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching