Replacement 7-Way Trailer Connector for 2018 Ram 1500

Question

Question:

Looking for a part number for a 7 blade replacement quick connect wiring with brake control for a 2018 Dodge Ram 1500 . There is a ground problem on the factory wiring and your experts suggested replacing with this quick connect

asked by: Alex C

0

Expert Reply:

It sounds like you are just looking for a replacement 7-way connector to replace the factory connector on your 2018 Ram 1500, and we have exactly what you need:

- 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket, Chrysler/Dodge OEM Plug Adapter # HM40975-11933

This will plug right into your factory socket and work perfectly as a replacement on your truck.

expert reply by: Kyle S

0

Answer 1

There is not a plug and play adapter for your Lance connector that we are aware of. Typically this is installed by the Lance dealer. A junction box/7-way plug kit like #HS381-9000 is an option you have to convert the camper to match the 7-way RV…

view full answer...

Answer 2

The nc code on the Tekonsha Prodigy brake controller indicates that no trailer is connected. When you step on the brake pedal though it should still say that the trailer is not connected. It is possible that there is a short being caused by a dirty…

view full answer...

Answer 3

For your 2016 Ram 1500, you can install the Tekonsha Prodigy P3 Trailer Brake Controller #90195 using the Tekonsha Plug-In Adapter, #3024-P. One end of this custom adapter will plug directly into the built-in port beneath the dash of your vehicle…

view full answer...

Answer 4

To install the excellent Tekonsha Prodigy P2 Trailer Brake Controller #90885 on your 2019 Ram 1500 you just need the Plug-In Wiring Adapter #3024-P. The factory brake controller port should be located underneath the dash, above and in front of the…

view full answer...

Answer 5

A travel trailer that's 20-24 feet in length is going to have brakes on it that will need to be activated when towing so you'll need a brake controller. For a brake controller I would recommend the Prodigy P3 Brake Controller part #90195.…

view full answer...

Answer 6

For your 2018 Ram 1500 Express, I recommend the Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center #41948. This is a Class V hitch receiver with a 2 inch receiver opening. It is rated for 1500 lbs tongue weight and 12,000 lbs towing and even…

view full answer...

Answer 7

If the rear end of your vehicle sags significantly when the trailer is hooked up then you could have an unsafe condition and your front end and tires will not wear properly. The weight is taken off of the front wheels of the vehicle and can cause…

view full answer...

Answer 8

It is not required that you install a weight distribution system for your Jayco Featherlite Trailer, but one will certainly be beneficial for any trailer that weighs more than 50 percent of the tow vehicle. This is the case with the 3,200 GVR on your…

view full answer...

Answer 9

The Curt hitch part #13333 is rated for use with weight distribution systems. This hitch has a capacity of 6,000 lb trailer weight without a WD system and then with a WD system is rated for up to 10,000 lbs. Either way it would have capacity for a…

view full answer...

Answer 10

The Curt Trailer Hitch Receiver #13333 referenced in your question is confirmed to fit your 2004 Dodge Ram 1500 as long as you replace what you have with the standard OEM bumper. The Curt hitch is going to attach to the truck's factory bumper…

view full answer...

Answer 11

If you are not getting power to the 12 volt pin on the 7-way on your 2018 Ram 2500, the most likely issue is that you have a blown fuse. I took a look at the online version of the owner's manual and it looks like it is in the F30 cavity in the…

view full answer...

Answer 12

We have the Pollak part #HM40975-11933 which fits your 2012 Ram 1500 and will give you a new 7-way and 4-way that connects to the factory wiring at the rear of the truck. It will just plug into the square connector your old 7-way is plugged into and…

view full answer...