Parts Needed To Use Roadmaster BrakeMaster Breaking System On RV With New Towed Vehicle

Question

Question:

I just bought a Class A Rv with a Road Master RM-9060 installed on the coach. I am looking to get the portions that install on the toad to complete the system. 2017 GMC Sierra 2055 HD What Items do I need to by to complete this braking system? Thank you

asked by: Larrs J

0

Expert Reply:

Congratulations on the new RV!

To allow you to use the Roadmaster BrakeMaster Braking System with BrakeAway for RVs with Hydraulic Brakes # RM-9060 that is installed on your RV with your 2017 GMC Sierra 2500 HD you will need the RoadMaster Second Vehicle Kit with BreakAway for BrakeMaster Systems # RM-98160, Roadmaster Stop Light Switch Kit # RM-751463, and Roadmaster BrakeMaster Custom Seat Adapter # RM-88308.

If you do not have the air cylinder you will also need the RoadMaster BrakeMaster Replacement Air Cylinder # RM-9100-50.

I have included videos to all of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

It sounds like you are asking if we have the proportioning valve available by itself separate from the RoadMaster BrakeMaster Second RV Kit for Hydraulic Brakes part #RM-98300 and if that is the case then yes, the RoadMaster Regulator Kit part…

view full answer...

Answer 2

In order to reuse the air cylinder from the Roadmaster BrakeMaster 9000 Braking System you are going to need the RoadMaster Second Vehicle Kit with BreakAway for BrakeMaster Systems part #RM-98160, the Replacement Mounting Post for RoadMaster…

view full answer...

Answer 3

Roadmaster states that the air reservoir for the breakaway portion of the Brakemaster should be mounted in the towed vehicle, most often in the engine compartment, but it may be attached anywhere an air line can be routed from the top of the air…

view full answer...

Answer 4

If you want to use the Roadmaster Brakemaster cylinder part #RM-9100-50 that your friend gave you I have listed the parts below that you will need to use it in the Lincoln. I highly recommend to use the custom seat adapter because if not you will…

view full answer...

Answer 5

I attached an exploded diagram that shows how the Roadmaster Base Plate kit part #RM-520 will bolt together. I also attached a set of installation instructions that should help you figure it all out as well.

view full answer...

Answer 6

I checked the owners manual of a 2016 GMC Canyon it states that the 4x4 models that have a Neutral and Four-Wheel Drive Low setting can be flat towed. For a base plate kit for your Canyon you would want the part #RM-523182-4 that has been confirmed…

view full answer...

Answer 7

The two ends of any tow bar should be within 3-inches above or below dead-level. Any more height difference than that can lead to the arms binding, which could affect tracking. We offer many 2-inch high/low hitch adapters, all shown on the linked…

view full answer...

Answer 8

If you have D-rings on the bumper of your 2003 Jeep Wrangler front bumper we have a couple options depending on the width of them. We have the part #RM-035-1 which is for 1 inch thick D-rings or the #RM-035 for 3/4 inch thick D-rings. The only…

view full answer...

Answer 9

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...